Booting NetBSD 5.1.2 on SparcStation 10

[T-Online]

Hi,

i just finished the installation. Now i do not know how to boot.

The drive has ID 0 and is connected to the builtin SCSI controller. I have created only one (root) partion on it.

I tried this without success: boot /iommu/sbus/***@f,400000/***@f,800000/***@0,0:a

Must i append the kernel path after this? If so what is the path?

Thanks.

Regards
Ralph

[Martin Husemann]

It all depends on your firmware settings. Typical call is:

boot disk

However, you did not tell us any details about the failure.

Martin

[Michael Thompson]

I thought that the default configuration had the boot disk ID set to 3.
With the disk set to 3 "boot disk" should work.

Post by Martin Husemann
boot disk
However, you did not tell us any details about the failure.
Martin